Leaking Palm Beach Water Heater Pressure Relief Valve

Posted by on Dec 9, 2014 in Gas Water Heater Repair West Palm Beach, Water Heater Repair West Palm Beach

The pressure relief valve of a water heater has a vital task – seeing to it the water heater tank does not blow up. So with that in mind, Water Heater Repair West Palm Beach wants to see to it homeowners are aware of how to best look after it. They will leak when the valve wears out or when the water storage tank pressure gets higher then the relief point.Hot Water Heater Repair West Palm Beach

We advise that at least two times a year, house owners test to make certain the pressure relief valve, or T&P valve as we will call it, is working effectively. All one needs to do is raise the deal with for a few seconds and let go of it. It must snap back to its initial position. When it is lifted, one might hear the sound of pressure being released , similar to the noise of air coming out of a tire pump when being detached. Also, a little water may come out too. Both are regular. If the valve has not been tested for a number of years, it may stick at first also.

Nevertheless, if the handle doesn’t snap back, or if it remains to leak some water, that is not regular. If it still leakages some, raise the handle a few more times to see if it will re-seat itself. You could wish to wait a day or so it see if it re-seats itself before assuming it needs to be changed.

Hot Water Heater Repair West Palm Beach would choose to deal with any T&P valve replacements for you, so though water heaters are usually fairly upkeep free, there are some safety precautions one ought to be mindful of. With that in mind here is an introduction of a pressure relief valve replacement.

1. The gas to the water heater has to be switched off, or the breaker for an electric water heater.
2. The cold water cut-off valve has to be closed .
3. The valve below the T&P valve needs to be opened to drain some water in order to relieve some of the pressure in the storage tank.
4. The overflow pipe of the T&P valve needs to be removed. It may need to be cut off if it is soldered or securely glued.
5. The pressure relief valve has to be unscrewed with a pipe wrench.
6. Wrap the brand-new T&P valve with Teflon tape and screw it in place. Make certain the overflow pipe opening is positioned away from the storage tank.
7. Reattach the drain pipe, also utilizing new Teflon tape.
8. Turn the water back on, and examine your work for any leaks.

The following video offers an overview of this process: