Identify a Gas Water Heater Not Heating

Posted by on May 20, 2015 in Gas Water Heater Repair West Palm Beach, Water Heater Repair West Palm Beach

A majority of the water heaters Water Heater Repair West Palm Beach receives repair requests for are gas water heaters. These are without a doubt the most favored type. Listed here are a number of self diagnostic steps one can test if the gas water heater is just not heating water in any way.

How to Self Diagnose a West Palm Beach Gas Water Heater Repair

This could appear evident, nevertheless verify to make certain the gas to the water heater is switched on. Move the gas control knob to PILOT to stop the burner from igniting while looking within. Take off the metal cover at the lower part of the water heater and take a look to check if the burner along with the pilot light are ignited.

If the water heater’s pilot light has gone out, go along with the directions on the storage tank to relight it (we have the simple measures to accomplish this detailed below). There may be a chance that the gas inlet valve is actually shut to some extent or entirely. If that is the fact, simply turn the handle parallel to the line and igniate the pilot. If the pilot continue to not ignite, then the difficulty may well be with the thermocouple. A lot of current water heaters possess a glow plug or spark ignitor rather than a pilot. Check out the owner’s handbook for a reference point.Gas Water Heater Repair West Palm Beach

If the burner is not on, replace the cover and be sure the thermostat is establish around 120 degrees F. If it is not, correct it, run on a hot water faucet in close proximity to the water heater, and wait around a little bit to verify that the water heater burner ignites. If it doesn’t ignite, keep the hot water running and try out decreasing and then increasing the temperature setting on the dial until eventually the burner ignites.

In the event that the burner ignites, replace the cover and switch the thermostat again to a suitable setting. If the burner will not ignite, allow us to examine the water heater. The heater’s thermostat could possibly be malfunctioning. A thermostat switch really should be accomplished by us.

Do you smell gas? If a smell much like garlic is observed, switch the gas valve control to the OFF placement. Hang on and examine if the gas odor is gone prior to relighting the pilot. If it does not pass, promptly switch off the gas supply valve, air out the area as best as you possibly can and phone the gas utility company.

Pilot Light Doesn’t Stay Lit

Attempt to relight the water heater initially. In common terms, move the water heater’s gas valve to the OFF status then to the PILOT location. Push the pilot button down in an effort to light it, and then hang on until a status light indicates the dial may be changed from PILOT to ON.

In cases where the pilot light continues going out, it’s possible the orifices may be unclean and blocked, that can make the flame too tiny to remain lit. Verify to be certain there is no evident dirt and debris clogging it.

In cases where everything seems clean, the trouble might be with the thermocouple. This is the element that runs from the temperature control straight into the flame of a pilot light and facilitates the main burner fire up as soon as the water temperature has moved too low. The pilot light may just be impacted if the thermocouple is bad or fails to come into contact with the pilot flame. Various property owners might feel safe changing a thermocouple, but Gas Water Heater Repair West Palm Beach would rather you call us to help.

Lower gas pressure or a not working gas control valve may also produce a pilot light to go out continuously. Call us if you believe this is the situation.