10 Minute West Palm Beach Water Heater Maintenance

Posted by on Feb 26, 2014 in Water Heater Repair West Palm Beach

We are going to put you to work today, but just for about 10 minutes. Yep, that’s all it will take for these 2 crucial water heater upkeep tasks; however, Water Heater Repair West Palm Beach understands they will do an outstanding task of assisting with 3 things:

  1. Having your water heater last as long as possible (that will save you cash).
  2. Seeing to it the water heater runs safely (we do not desire it to explode).
  3. Having it run as energy efficiently as possible (also saving you money).

So with that in mind, are you ready to invest 10 minutes once or twice a year to assist in saving some cash? Water Heater Repair West Palm Beach FL thought so.

Testing the T&P Relief Valve

Frequently called the T&P Valve, or the temperature and pressure relief valve, has an essential task. It helps ensure excess pressure does not build up inside the water tank, or in much more easy terms, it ensures the water heater does not blow up. As the photo shows, it has a lever or little manage on it. All you need to do is raise it part means and afterwards let go of it. Hopefully, it snapped back to its shut position quickly. If it is working appropriately, a little water can be heard going into the drain pipe below the lever you just lifted and you maybe heard some pressure being released. If none of these things have actually taken place during the test, the valve will have to be replaced.

As inspectapedia.com states: “dripping TP relief valves are unsafe. The hazard is that minerals in the water supply accumulate inside the valve during the passage of hot water through the valve assembly. That accumlation of scale will eventually block operation of the relief valve, causing the relief valve to fail to operate properly if unsafe pressure or temperature occurs in the water heater in the future. The risk, ultimately, is a water heater tank or heating boiler explosion.”  (read more…)

Do a Mimi Water Heater Tank Flush

By nature, rust and corrosion will occur inside the water storage tank thanks to the chemical reactions taking place with all the elements inside that are required to warm the water. We will not get too technical here, however it is easy to help prevent this from happening by doing a flush or draining of all or some of the water in the storage tank.

For just a small flush, put a container under the drain valve below the tank. Open the drain valve and fill the pail with water. Drain a minimum of a couple of gallons of water in total. Let the water sit in the bucket for a couple of minutes to settle and examine if there is much that settles to the bottom of the container. If there is, if the water heater has not been drained for a very long time (or ever), it would be best to do a full flush of the tank to get as much of the sediment out as possible. You will wish to turn the temperature dial down and could want to let the water cool down for about an hour first so it is not too hot while draining it. Likewise, it would be much easier to connect a hose to the drain valve and let the water go outside instead of making use of pails.

If the water looks fairly clean and clear from the mini test you should be all set. When the water heater has a large quantity of sediment inside of it, it can make loud popping sounds and it lowers its effectiveness too.

Though water heaters are fairly upkeep free and easy to operate, any time you feel the tiniest uneasy or are not sure of what to do, it is always best to have a plumbing expert assist with the circumstance.

Water Heater Repair West Palm Beach